top app on mac for logic gate circuit design

In this software, circuits can easily be converted into a reusable Modules.

A Module may be used to built more complex circuits like CPU.

The circuit working can be analyzed by using output parts like LEDs, Seven Segment Display as well as CRT and digital Oscilloscope provided in the software.

You can design combinational, synchronous and asynchronous sequential circuits.

Each logic gate performs a function based on Boolean values with the help of signals from logic gates.

In general digital circuits are represented using two types of digital systems such as a combinational system and a sequential system where a combinational system represents the same output when it receives the same input and a sequential system is described as a combinational system with some of the outputs as inputs i.e.

As digital circuits are made from analog components we need to make sure that analog components behavior should not dominate the digital behavior.

It is true that every interview is different as per the different job profiles.

Here, we have prepared the important Digital electronics interview questions and answers which will help you get success in your interview.

These Digital electronics interview questions are divided into two parts are as follows.

Both latch and flip-flop will be used in sequential logic and requires a clock signal.

Latch output will track the input when the signal is high i.e.

Whereas in flip-flop input will be stored only when there is a risingfalling edge of the clock and it is immune to glitches where Latch is sensitive to glitches.

Latches need fewer logic gates than flip-flop to implement, so latches are faster than a flip-flop.

As both numbers and alphabets both are used to represent numbers in the hexadecimal number system it is called an alphanumeric number system.

Most of the models will depend only on state whereas Mealy model output depends on both inputs and states.

When the signal goes from high to low it depends on the resistor that pulls down it called pull-down resistor.

So, most people will refer to use signals which are inactive low.

In order to avoid this situation, the clock pulse needs to have the time duration which is less than propagation delay time for F-F which is restrictive.

So the alternative is master-slave or edge-triggered construction.

The edge-triggered flip-flop will change its state either at the positive edge or negative edge of the clock pulse.

The edge-triggered flip-flop is sensitive to its inputs only at this transaction of a flip-flop.

I hope you will have good preparation after reading this 2018 digital electronics interview questions article and I will suggest practicing questions on logical gates for Interview preparation.

By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to our Privacy Policy.

Top App On Mac For Logic Gate Circuit Design